帶 * 為必填項 關閉
*發送對象: | |
---|---|
*信息標題: |
|
期望價格: |
|
*留言內容: |
|
*驗證碼: | |
*聯系方式: | |
聯系人: | |
手機: | |
訂貨量(千克)
價格(不含稅)
1
200.00元/千克
10
180.00元/千克
供應標題:鋁合金耐酒精油墨
價格:電儀
發布公司:上海凱賢印刷科技公司
供貨總量:10000
聯系人:楊洪
發貨地點:上海 上海 嘉定區
發布時間:2024年07月01日
有效期至:2025年03月03日
在線詢盤:在線詢盤
產品綜合信息質量:未計算
鋁合金耐酒精油墨
1、油墨特性:低氣味,高光澤,色澤鮮艷,遮蓋力強,耐酒精,耐汽油,抗腐蝕。
2、適用材料:主要應用于各種五金、鋁合金、不銹鋼、氧化鋁、白鐵電鍍、PP材料。
3、技術參數:
a.粘度:8000—12000CPS;
b.細度:5UM↓ 、光澤:60°↑ ;
c.干燥條件:65℃—70℃,25min 自干24小時
d.鉛筆硬度:2H↑ ;
e.耐鹽務性:24H;
f.耐酒精:99%乙醇500g力來回30次;
g.耐磨:500g力來回超過30次;
h.過網性:77T—145T網紗〔金、銀粉調配顏色除外〕
4、稀釋劑的選擇:稀釋劑:S—783:便用前添加13%—15%的DB—01固化劑。
5、注意事項:
a.使用前將油墨與固化劑攪拌均勻,用后4個小時后須更換新的油墨,以便出現干網,和固化劑凝固!
b.根據需要可添加15%—20%的稀釋劑進行稀釋;
c.施工件在施工前清除表面油漬及污物;
d.需多色套印時應等前面的顏色表干后進行套色;
e.在作測試時應先讓墨層完全干燥;
d.不得將油墨與其它油墨混合及配色,添加固化劑后,效果會大大的改善,若加固化劑后請將油墨在4小時用完。
6、應急處理措施:
a.如浸濺到眼部立即清水清洗,嚴重者就醫。
b.滅火急救措施:用干粉,泡沫滅火器或沙子滅火。
※備注:由于材料及使用中的變數,可能是結果會有變化,以上數據僅供參考,使用前請自行測試。
1, ink characteristics: low odor, high gloss, bright color, hiding power, alcohol, gasoline, corrosion resistance.
2, applicable materials: mainly used in all kinds of hardware, Aluminum Alloy, stainless steel, aluminum, tin plating, PP material.
3, technical parameters:
A. viscosity: 8000 - 12000CPS;
B.: 5UM:: gloss, fineness of 60 degrees up;
C. drying conditions: 65 DEG C - 70 DEG C, 25min dry for 24 hours
D. pencil hardness: 2H up;
Salt resistance: 24H e.;
F. alcohol resistance: 99% ethanol 500g force back and forth 30 times;
G. wear: 500g force back and forth more than 30 times;
H. network: 77T - 145T Jacobs, except gold and silver powder colors.
4, diluent choice: diluent: S - 783: before use, add 13% - 15% of DB - 01 curing agent.
5, matters needing attention:
A. use before the ink and curing agent mixing evenly, use 4 hours later, must replace the new ink, in order to appear dry nets, and curing agent solidification!
B. may add 15% - 20% diluent to dilute as needed;
C. construction parts to remove surface grease and dirt before construction;
D. multicolor, should wait for the color table in front of dry color;
E. should allow the ink layer completely dry when testing;
D. shall not ink and other ink mixing and color matching, add curing agent, the effect will be greatly improved, if add curing agent, please ink in 4 hours run out.
6, emergency treatment measures:
A. if splashed to the eye, immediately clean water, serious medical treatment.
B. fire emergency measures: use dry powder, foam extinguisher or sand to extinguish fire.
Please note: due to the material and the use of variables that may be the result of a change, the above data for reference only, please test before use.
橡膠漆絲印油墨 【產品特性】 1、超消光視覺,板面柔和,手感柔軟舒適
2024-04-12電泳表面絲印移印油墨 【產品信息】 產品名稱:雙組份金屬油墨 常規顏
2024-04-12大理石專用絲印油墨 適用范圍:各種塑膠,電鍍(含水電鍍
2024-04-12單組份陶瓷油墨 【一,油墨使用技術參考】單組份免烤絲網印刷油墨是為是
2024-04-12詆毀、惡意攻擊、無事實依據、非正能量的消極評語會被管理員刪除,您的評語可能對其他人有很高的參考價值。